FIND THE PRODUCT YOU NEED!
Keysight-Agilent E4416A-003
Keysight-Agilent E4416A-003
Exfo PM-1600
High-Speed Power Meter
The Exfo PM-1600 High-Speed Power Meter and PM-1100 Benchtop Optical Power Meter deliver accurate power measurements over a wide dynamic range along with high resolution and excellent linearity. Choose them for automatically measuring discrete values such as insertion loss or, alternately, for continuous monitoring and data acquisition. These stand-alone power meters provide exceptional performance, flexibility, user-friendliness and extensive integration capabilities.
PM1100/PM1600
Use the BFA-3000 Universal Bare-Fiber Adapter with the PM-1600W High-Speed benchtop optical power meter, and ensure repeatable measurements when testing non-connectorized components.
IN STOCK
Description
Keysight-Agilent E4416A-003
EPM-P power meter specifications
Specifications describe the instrument’s warranted performance and apply after a 30 minute warm-up. These specifications are valid over its operating and environmental range unless otherwise stated and after performing a zero
and calibration procedure.
Supplemental characteristics are intended to provide additional information; useful in applying the instrument by giving typical (expected), but not warranted performance parameters.
These characteristics are shown in italics or labeled as ‘typical’, ‘nominal’ or ‘approximate’. Measurement uncertainties information can be found in, Compatibility, the EPM-P series power meters operate
with the E-series E9320 family of power sensors for peak,
average and time-gated power measurements.
The EPM-P series also operates with the existing 8480 series, E-series
CW and the Keysight-Agilent E4416A-003 range of power sensors for average
power measurements.
For specifications pertaining to the 8480 and E-series CW and Keysight-Agilent E4416A-003 power sensors, please refer to the, EPM Series Power Meters E-Series and 8480
Series Power Sensors, Technical Specifications,
literature number 5965-6382E.
Measurement modes, the EPM-P series power meters peak, average and time-related measurements
Average only mode. This mode is primarily for average power measurements on low-level signals, when using Keysight-Agilent E4416A-003 sensors, and is the mode used with 8480 series sensors, E-series CW sensors and E-series E9300 sensors.
Single sensor dynamic range E-series E9320 peak and average power sensors:
70 dB maximum (normal mode);
85 dB maximum (average only mode)
E-series CW power sensors: 90 dB
E-series E9300 average power sensors:
80 dB maximum
8480 series sensors: 50 dB maximum
Display units
Absolute: Watts or dBm
0.01, 0.001 dB in logarithmic
mode, or 1 to 4 significant digits
in linear mode.
Offset range: ±100 dB in 0.001 dB increments,
to compensate for external loss
or gain
Video bandwidth: 5 MHz (set by meter and is
sensor dependent)
Note that the video bandwidth represents the ability of
the power sensor and meter to follow the power envelope
of the input signal. The power envelope of the input signal
is, in some cases, determined by the signal’s modulation
bandwidth, and hence video bandwidth is sometimes
referred to as modulation bandwidth.
