FIND THE PRODUCT YOU NEED!
Keysight-Agilent 8481A
Keysight-Agilent 8481A
The 8481A Power Sensor has a power range of 1W to 100 mWatts and operates over a frequency range of 10MHz to 18GHz. The sensor is designed for use with the EPM-441A, EPM-442A, 435B, 436A, 437B, 438A, 70100A and E1416A power meters. The unit uses a Type-N (male) connector. Option 001 – APC-7 connector.
IN STOCK
Description
Keysight-Agilent 8481A
Specifications
Specifications describe the instrument’s warranted performance and apply after a 30 minute warm-up.
These specifications are valid over its operating/environmental range unless otherwise stated and after performing a zero and calibration procedure.
Supplemental characteristics
Supplemental characteristics (shown in italics) are intended to provide additional information, useful in applying the instrument by giving typical (expected), but not warranted performance parameters. These characteristics are shown in italics or labeled as “typical”, “nominal” or “approximate”.
For information on measurement uncertainty calculations, refer to application Note 64-1C, “Fundamentals of RF and Microwave ower Measurements”, literature number 5965-6380E.
Frequency range: 9 kHz to 110 GHz, sensor dependent
Power range: –70 dBm to +44 dBm (100 pW to 25 W), sensor dependent.
Power sensors: Compatible with all 8480 series and E-series sensors
Single sensor dynamic range:
90 dB maximum (E-series sensors),
50 dB maximum ( 8480 series sensors).
Display units:
Absolute: Watts or dBm.
Relative: Percent or dB.
Display resolution: Selectable resolution of 1.0, 0.1, 0.01, and 0.001 dB in Log mode, or 1 to 4 digits in linear mode.
Default resolution: 0.01 dB in log mode, 3 digits in linear mode.
